• Air Cleaning Blowers help clean air with virtually no maintenance for months or even years in normal operations, even in dusty conditions.
  • No pressurized air required for cleaning.
  • Units do not shake or make excessive noise because they require no cleaning cycle.
  • Install like other blowers in air curtains, pressurizers, pre-heating, and other systems, supplying cleaned air at a steady flow rate and static pressure.
  • Air-cleaning ventilators install like other ventilation, pressurization and exhaust units, in, or onto, a wall.
  • They remove particles that would accumulate on surfaces, or that regulators prohibit exhausting into the outside atmosphere.
  • Specially-designed stand-alone (free-standing) air-cleaners clean air within open areas or large indoor space such as dusty factory floors, construction sites or tunnels, usually to target a specific location (or people) with clean air.
  • ACB’s provide the clean air and air movement necessary to pressurize control rooms, operator cabs, electrical sub-stations, and other dust-sensitive enclosures located in sandy, dusty and other extreme environments.
  • Sand and other particles removed from the air are ejected back into the environment or onto the ground. When the air cleaners eject the particles back into the surrounding air where they came from, the ACBs avoid the accumulation of waste that users would need to dispose of, especially if they collected quantities sufficiently large to qualify as “hazardous waste”.
  • ACB’s are easier to design into systems than air filters because they provide steadier performance: airflow, air pressure and energy consumption all remain consistent
  • Made to resist corrosion and abrasion, cabinets made with stainless steel (type 304L or 316L).
  • Mechanical controls eliminate vulnerability of electronics and their high cost to repair
  • Complete units meet NEMA 4X and IP56 standards. All controls provided protected in NEMA 4X (IP66) or NEMA 4/7/9 enclosures.
  • Units available for hazardous locations (“explosion-proof”) — Divisions/Zones 1 or 2
  • Energy efficient even under harsh conditions, because static pressure and energy does not increase over time
  • Standard electrical configurations available: 115/60/1, 208-230/50-60/1, 208-230/50-60/3, 460/60/3 and 380/50/3